Is there a reset button on a pressure washer?
When the trigger is released, water flow stops which the TSS sensed and immediately shuts the unit off. So to review, if the Reset button has been pressed and is holding and the power switch is ON, the power washer is supposed to start up for a second or two and immediately shut off.
Why would an electric pressure washer stop working?
Remove and clean it, and you should be good to go. Assuming water is flowing through the pump properly, start the engine, hook up the hose and wand and see if it works. If not, you have a collapsed or kinked hose or a clogged wand. Both problems can most likely be fixed quickly without professional help.
Where is the fuse on an electric pressure washer?
Some electric pressure washers have a GCFI located near the end of the power plug. Press the button to reset the GFCI on the power cord to get your pressure washer electrical power. A fuse is usually located in the GCFI area of the electric power washer power cord.
Can electric pressure washers overheat?
An electric pressure washer can overheat, but not in the same way that a gas unit will. Electric pressure washers automatically shut down the motor when the wand trigger is closed. The main culprit that will cause your pressure washer to overheat is running it too long in direct sunlight on a hot day.
Why did my pressure washer suddenly stop?
A clogged carburetor is most commonly caused by leaving fuel in the pressure washer for a long period of time. Over time, some of the ingredients in the fuel may evaporate, leaving behind a thicker, stickier substance. This sticky fuel can clog up the carburetor and cause the engine to run stall.
Who manufactures Sun Joe pressure washers?
The parent company is Snow Joe, which includes Snow Joe®, Sun Joe® and Aqua Joe® brands. The Snow Joe company was founded in 2004 and is both the #1 brand in cordless and electric snow blowers and the #1 brand in electric pressure washers.
Is it OK to start a pressure washer without water?
Using pressure washers without water is risky and can damage your machine. The water helps to cool the pump, and without it, the pump can get overheated and breakdown.